Filter
Top Products
48
PS Programming
Canceling the PS Registration (Level 2)
To cancel your PS registration, use the sys-
tem program [651], “PS Termination”. If
“Rejected” or “Time Out” is displayed in
program [651], delete the PS again by PS
programming. It may take a few seconds
to complete the cancelation.
Refer to System Programming in the
Installation Addendum for program [651].
Setting the Guidance Menu (Level 0)
You can enable the guidance menu. This
will show the selectable keys, and helps you
operate the PS without the operating manual.
(Default: OFF)
Setting the PS Programming Password (Level 1)
You can set the PS Programming pass-
word. In this case, you must enter your
password in order to display the following
programs.
– Controling the directory lock
– Clearing the settings in memory
– Setting the PS programming password
(Default: DISABLE)
Setting the DECT System Lock (Level 2)
You can enable or disable the DECT
System Lock. If enabled, you must enter
your password when entering the PS
Programming mode in order to display the
following programs.
– Selecting the DECT system
– Canceling the PS registration
– Setting the DECT system lock
(Default: DISABLE)
GUIDANCE
= OFF
CANCEL DECT-SYS
= DECT-SYS1
BOOK ( )=NEXT
OK ( )=OK
# ( )=NEXT
OK
* ( )=PREV
HOLD ( )=BACK
C ( )=EXIT
C
Guidance Menu
PS PASSWORD
= DISABLE
DECT-SYS LOCK
= DISABLE