Filter
Top Products
47
PS Programming
Selecting the DECT System (Level 2)
When the registration of your PS is com-
pleted, this program is automatically set to
the registered DECT system (DECT-SYS1
through DECT-SYS4). If you want your
PS to access all connected terminals auto-
matically, select AUTO in this program.
After changing the selection, it may takes a
few seconds to complete the setting.
This program is only displayed when more
than two fixed terminals are connected.
Selecting the Standby Display*
1
(Level 0)
You can select the number, extension num-
ber (EXT), DECT system number (DECT-
SYS-NO.), or DECT system and extension
number (DECT-SYS-NO.&EXT), which is
displayed in the standby mode. You can
also select not to display any of these num-
bers (OFF).
(Default: OFF)
Selecting the Date / Time Display*
1
(Level 0)
You can select showing only the date
(DATE) or date and time (TIME) in the
standby mode display.
(Default: TIME)
Clearing the Settings in Memory (Level 1)
All of the following settings can be
returned to their default settings at one
time.
– Call log numbers*
2
– Ringer volume
– Receiver volume
– PS Programming items
(except: Selecting the DECT System;
Canceling the PS Registration;
Setting the PS Programming Password;
Setting the DECT System Lock)
*
1
: Only displayed when registered to a Panasonic Digital Super Hybrid System and “ ” is displayed.
*
2
: Only cleared when registered to a system other than a Panasonic Digital Super Hybrid System.
STANDBY DISPLAY
= OFF
DATE/TIME DISPLY
= TIME
ACCESS DECT-SYS
= DECT-SYS1
MEMORY CLEAR