Filter
Top Products
8
Getting to Know the AV Receiver
The actual front panel has various logos printed on it. They are not shown here for clarity.
For detailed information, see the pages in parentheses.
A
STANDBY/ON button (39)
Sets the AV receiver to On or Standby.
B
STANDBY indicator (39)
Lights up when the AV receiver is on Standby and
flashes while a signal is being received from the
remote controller.
C
ZONE 2 indicator (83)
Lights up when Zone 2 is on.
D
Remote-control sensor (13)
Receives control signals from the remote controller.
E
Display
See “Display” on page 10.
F
DISPLAY button (59)
Displays various information about the currently
selected input source.
G
MASTER VOLUME control (48)
Sets the volume of the AV receiver to –
∞
dB, –81 dB,
–80 dB through +18 dB (relative display).
The volume level can also be displayed as an abso-
lute value. See “Volume Setup” on page 77.
H
POWER switch
American and Australian models don’t have this
switch.
This is the main power switch. When set to OFF, the
AV receiver is completely shutdown. When set to
ON, it’s in Standby mode and the STANDBY indi-
cator lights up.
I
PURE AUDIO button and indicator (60)
Selects the Pure Audio listening mode. The indica-
tor lights up when this mode is selected. Pressing
this button again selects the previous listening
mode.
J
Input selector buttons (48)
Select the following input sources: MULTI CH,
DVD, VIDEO 1, VIDEO 2, VIDEO 3, VIDEO 4,
TAPE, TUNER, CD, or PHONO.
The [MULTI CH] button selects the multichannel
DVD input.
Front Panel
STANDBY/ON
STANDBY
MASTER VOLUME
PHONO
ZONE 2
DISPLAY
PURE AUDIO
TUNERTAPE
VIDEO 4VIDEO 3VIDEO 2VIDEO 1
DVDMULTI CH CD
OFF
ON
POWER
PUSH TO OPEN
4 5 76
1 2 3
J
8
9
Front flap
Not North American and Australian models
Push here to open
the flap