Filter
Top Products
12
Getting to Know the AV Receiver—Continued
N RS232
This port is for connecting the AV receiver to home
automation equipment and external controllers.
O VOLTAGE SELECTOR (on some models)
Some models have a volt-
age selector switch for
compatibility with power
systems around the world.
Before you plug in such a
model, make sure that the
voltage selector is set to the correct voltage for your
area. If it isn’t, use a small screwdriver to select the
correct setting. For example, if the voltage in your
area is 120 volts, set the selector to “120 V.” If it’s
between 220 and 240 volts, set it to “220-240 V.”
P REMOTE CONTROL
This (Remote Interactive) jack can be con-
nected to the jack on another -capable
Onkyo component, for remote and system control.
To use , you must make an analog audio connec-
tion (RCA) between the AV receiver and the other
component, even if they are connected digitally.
Q GND screw
This screw is for connecting a turntable’s ground
wire.
R PHONO IN
This analog audio input is for connecting a turnta-
ble.
S CD IN
This analog audio input is for connecting a CD
player’s analog audio output.
T TAPE IN/OUT
This analog audio input and output are for connect-
ing a recorder with an analog audio input and out-
put, such as a cassette deck, MD recorder, etc.
U VIDEO 3 IN
A VCR for playback only, or a cable or satellite
receiver can be connected here. There’s S-Video and
composite video input jacks for connecting the
video signal.
V VIDEO 1 IN/OUT and VIDEO 2 IN/OUT
One or two video components can be connected
here for recording and playback, such as a VCR.
There’s S-Video and composite video input and out-
put jacks for connecting the video signal.
W DVD IN
This input are for connecting a DVD player. There’s
S-Video and composite video input jacks for con-
necting the video signal, and stereo (FRONT) and
multichannel 5.1/7.1 jacks for connecting the ana-
log audio signals.
X PRE OUT FRONT L/R, SURROUND L/R,
CENTER, SUBWOOFER, and SURR BACK
L/R
This 5.1/7.1 analog audio output can be connected
to the analog audio input on another power ampli-
fier, for when you want to use the AV receiver as a
preamplifier. The SUBWOOFER jack is for con-
necting a powered subwoofer.
Y FRONT, CENTER, SURROUND, and
SURROUND BACK SPEAKERS
These terminal posts are for connecting the front
L/R, center, surround L/R, and surround back L/R
speakers.
Z AC OUTLETS
These switched AC outlets can be used to supply
power to other AV components. The type and num-
ber of outlets depends on the country in which you
purchased your AV receiver.
See pages 19–38 for hookup information.