Filter
Top Products
68
Advanced Setup
—Continued
■
b. PCM fs = 96k
With this setting you can specify the listening mode to be
used when a PCM 96 kHz digital audio signal is played
(DVD, etc).
Only listening modes that can be used with the PCM
96 kHz signal format can be selected.
• The Last Valid option means that the listening mode
selected last will be used.
■
c. Dolby D
With this setting you can specify the listening mode to be
used when a Dolby Digital format digital audio signal is
played (DVD, digital cable/satellite, etc).
Only listening modes that can be used with Dolby Digi-
tal can be selected.
• The Last Valid option means that the listening mode
selected last will be used.
■
d. DTS
With this setting you can specify the listening mode to be
used when a DTS format digital audio signal is played
(DVD, LD, CD, etc).
Only listening modes that can be used with DTS can be
selected.
• The Last Valid option means that the listening mode
selected last will be used.
■
e. D.F. 2ch
With this setting you can specify the listening mode to be
used when a 2-channel (2/0) digital audio signal (PCM,
Dolby Digital, DTS) is played (DVD, digital cable/satel-
lite, etc).
Only listening modes that can be used with 2-channel
digital audio can be selected.
• The Last Valid option means that the listening mode
selected last will be used.
■
f. D.F. Mono
With this setting you can specify the listening mode to be
used when a mono digital audio signal is played (DVD,
etc).
Only listening modes that can be used with mono PCM,
Dolby Digital, or DTS can be selected.
• The Last Valid option means that the listening mode
selected last will be used.
Notes:
• The b, c, d, e, and f settings are available only when an
digital audio input is assigned to the selected input
source.
•You can select other listening modes during playback
(see page 59), however, the listening mode assigned
here will be resumed after the TX-NR901 has been set
to Standby.
This section explains the audio and listening mode set-
tings you can use to tailor the sound as you like.
Note:
• This procedure can also be performed by using the
TX-NR901’s [SETUP] button, [ ]/[ ]/[ ]/[ ]
buttons, and [ENTER] button.
Audio Adjust Functions
1
Press the scroll wheel, and then
press the [SETUP] button.
The main menu appears onscreen.
2
Use the Up/Down [ ]/[ ] but-
tons to select “3. Audio Adjust,”
and then press the [ENTER] but-
ton.
The Audio Adjust menu appears.
3
Use the Up/Down [ ]/[ ] but-
tons to select the menu items,
and then press the [ENTER] but-
ton.
The Tone Control menu is shown here.
4
Use the Up/Down [ ]/[ ] but-
tons to select the settings, and
use the Left/Right [ ]/[ ] but-
tons to set them.
The settings are explained below.
5
Press the [SETUP] button.
The setup menu closes.
ENTER
ENTER
ENTER
ENTER
Advanced Menu
3.Audio Adjust
3-1.Tone Control
a.Bass : 0
b.Treble : 0
Quit:|SETUP|
ENTER