Filter
Top Products
50
En
Note
•If the “Surr Back” setting is set to “None” (➔ 46), this setting
cannot be selected.
•If the “Front High” or “Front Wide” setting is enabled (➔ 46),
this setting is fixed at “Manual”.
DTS
■ Neo:6 Music
Center Image
`0 to 2
to 5
The DTS Neo:6 Music listening mode creates 6-channel
surround sound from 2-channel stereo sources. With
this setting, you can specify by how much the front left
and right channel output is attenuated in order to create
the center channel.
Setting a value “0” in the middle is set to hear a sound.
Sound is spread in left and right (the outside) so that the
set value is made big. Please adjust by liking.
Audyssey DSX™
■ Soundstage
`–3dB to Reference
to +3dB
With this setting, you can adjust the soundstage when using
Audyssey DSX™.
Note
•If the “Center” setting is set to “None”, or both “Front High”
and “Front Wide” settings are set to “None” (➔ 46), this setting
cannot be selected.
Theater-Dimensional
■ Listening Angle
`Wide
:
Select if the listening angle is 40 degrees.
`Narrow:
Select if the listening angle is 20 degrees.
With this setting, you can optimize the Theater-Dimen-
sional listening mode by specifying the angle of the
front left and right speakers relative to the listening
position. Ideally, the front left and right speakers should
be equidistant from the listening position and at an
angle close to one of the two available settings.
LFE Level
■ Dolby Digital
*1
, DTS
*2
, Multich PCM, Dolby
TrueHD, DTS-HD Master Audio, DSD
*3
`– dB, –20dB, –10dB, or 0dB
With these settings, you can set the level of the LFE (Low
Frequency Effects) channel individually for each input
sources.
If you find that low-frequency effects are too loud when
using one of these sources, change the setting to –20 dB or
– dB.
*1
Dolby Digital and Dolby Digital Plus sources.
*2
DTS and DTS-HD High Resolution Audio sources.
*3
DSD (Super Audio CD) sources.
Items can be set individually for each input selector.
Main menu Source Setup
Audyssey
When Audyssey MultEQ
®
Room Correction and Speaker
Setup is complete, the “Equalizer” (➔ 47) will be set to
“Audyssey” and the “Dynamic EQ” will be set to “On”.
■ Dynamic EQ
`Off
:
Audyssey Dynamic EQ
®
off.
`On:
Audyssey Dynamic EQ on.
The Dynamic EQ indicator will light (➔ 9).
With Audyssey Dynamic EQ, you can enjoy great
sound even when listening at low volume levels.
Audyssey Dynamic EQ solves the problem of deterio-
rating sound quality as volume is decreased by taking
into account human perception and room acoustics. It
does so by selecting the correct frequency response and
surround volume levels moment-by-moment so that the
content sounds the way it was created at any volume
level — not just at reference level.
Note
• If Pure Audio or Direct listening mode is selected, this setting
cannot be selected.
20°/40°
Front left speaker Front right speaker
Source Setup
Preparation
Press the input selector buttons to select an input source.