Filter
Top Products
58
◆ Dividing a selected track – Divide
• You can execute this function only when the input
source is MD and an MD is playing or paused.
• If a selected track has a name (see page 52), the first
part will retain the name after the track is divided.
• To cancel the operation, press MD .
Moving, dividing, combining, and erasing MD tracks (continued)
1
Insert the MD, then select MD as
the source.
Use a recordable MD with the record-
protect tab closed.
2
Turn MULTI JOG to select the
track to divide.
You may press to fast forward or
to fast reverse on the remote controller
to help locate the desired dividing-point.
3
Press MD .
Playback starts.
4
Press MD at the desired
dividing.
The MD pauses.
5
Press EDIT/CLEAR/NO and turn
MULTI JOG until “Divide?”
appears in the display.
1
3, 4
2, 5-8
5
/
/
/
6
Press MULTI JOG.
“Rehearsal” and “Position OK?” appear
alternatively and an approximately four-
second section around the dividing
point will be played repeatedly.
7
If necessary, turn MULTI JOG to
fine tune the dividing point.
You may adjust the dividing point
between the values of –45 and +45 (or
approx. +/–3 seconds in SP mode)
within the selected track.
8
Press MULTI JOG to divide.
“Complete” appears in the display.
The selected track is divided and all the
tracks are renumbered from the top.
Approximately four
seconds rehearsal play
The dividing point
Approximate four sec-
onds rehearsal play
+/– 45 steps
The dividing
point
1 2 34
134
14523
Dividing a selected track
Renumbering the tracks