Filter
Top Products
27
Dubbing CD to MD (CD
dubbing)
• This operation is one-touch recording
that enables the DLA LINK.
• The tracks are automatically numbered.
1
Insert a CD and MD.
See Step 1 of “Playing a CD” on page 20.
See Step 1 of “Playing an MD” on page 22.
Use a recordable MD.
Canceling the dubbing
operation
When playback of a CD is com-
plete, or an MD is recorded up to
the end, recording automatically
stops. To cancel the operation
during recording, press MD or
CD .
Note
DLA LINK may take up to 90 sec-
onds.
Tip!
• Recorded songs are automati-
cally numbered during CD-to-
MD dubbing.
• CD-R or LINE input source is
audible during CD dubbing.
(The level meter in the display
indicates the level of the
recording source. The FR-N3X
DIGITAL OUT connector out-
puts the CD audio.)
Notes on CD dubbing
• You cannot change the input
source.
The (play/pause) and
(eject) are disabled.
2
Check the necessary recording time.
1Press CD/MD repeatedly to select “CD.”
2Check the CD’s total playback time.
If the display does not indicate the total playback time,
press DISPLAY repeatedly.
3Press CD/MD to select “MD.”
4Check the available recording time on the MD.
If the display does not indicate the available recording
time, press DISPLAY repeatedly.
If some data has already been recorded in the MD, the
additional songs will be recorded and numbered
sequentially following the existing data in the MD.
3
Press CD DUBBING to start dubbing.
The FR-N3X searches for the peak level in the CD and sets
the optimum recording level. (DLA LINK)
Then, it starts recording.
When CD playback is completed or the recording reaches
the end of the MD, the recording stops.
Checking the recording result
After recording is complete or you press to stop recording, press
MD on the FR-N3X or on the remote controller. Playback
starts from the top of the recording.
1
2-
3
2
1
3
/
Total playback time
Available recording time
(DISC REMAIN lights up.)
“X2 Dubbing?” appears for
three seconds.
“CD-MD Dubbing” scrolls
on the display.
/