Filter
Top Products
17
To cancel the clock setting
Press EDIT/CLEAR/NO.
◆ Checking the time and the day of
the week
To check the time and the day of the week, press
CLOCK CALL on the remote controller. To switch
between the 12-hour and 24-hour displays, press DIS-
PLAY while the current time is indicated on the dis-
play.
To display the current time while the unit is in Standby
mode, first turn on the power to the unit, then press
and hold down the STANDBY/ON button for more
than two seconds.
To cancel the current time indication, press and hold
down the STANDBY/ON button for more than two sec-
onds while the power is on.
If the unit displays the current time during Standby
mode, standby power consumption will increase.
Setting the day of the week and the time
You can select either the 12-hour or 24-hour display. (This section explains how to set the
time based on the 12-hour display.)
DISPLAY
EDIT/
CLEAR/NO
1
2-6
1
Press TIMER repeatedly until
“Clock” appears in the display.
2
Press MULTI JOG.
You can now set the day of the week.
If you prefer the 12-hour display, press
DISPLAY.
3
Turn MULTI JOG to select the cur-
rent day of the week.
4
Press MULTI JOG to confirm the
setting.
You can now set the time.
5
Turn MULTI JOG to set the cur-
rent time. (This example shows
the 24-hour display.)
6
Press MULTI JOG in sync with
the time signal.
The clock starts operating and a dot
indicating seconds starts to flash.
CLOCK CALL