Filter
Top Products
18
Note
Auto presetting may store noise instead of a station with a
clear signal to some preset channels, depending on your
location. In such cases, erase the preset manually (see
page 50).
If auto presetting is unsuccessful
Check the antenna (aerial) connection and position (see
page 6).
If you have a power failure or disconnect the AC power
cord (mains lead)
Memory will normally be preserved for three days after the
power supply has stopped. If the data in memory has been
erased, repeat auto presetting.
◆ Customizing the preset channels
The following additional functions are available:
• Naming a preset channel (see page 52)
• Erasing a preset channel (see page 50)
• Copying the radio station in the selected channel to
another (see page 51).
Programming FM stations automatically — Auto Preset
Auto presets store the frequencies of radio stations into memory so you can select your
favorite channels without tuning manually. Radio station signals can be automatically
located and stored. This function does not apply to AM stations (see the next page).
1
3-5
3
2
If any radio stations are preset before you start
the auto preset procedure, they will be replaced
with new presets.
Before auto presetting
1
Press STANDBY/ON to turn on
the unit.
2
Press FM/AM to display “FM.”
To improve the FM reception, adjust the
antenna position.
3
Press EDIT/CLEAR/NO and turn
MULTI JOG to display “AutoPre-
set?”
4
Press MULTI JOG.
The confirmation message “AutoPre-
set??” appears in the display.
To stop auto presetting, press EDIT/
CLEAR/NO.
5
Press MULTI JOG.
Auto presetting starts. It scans for the
best signal quality radio stations start-
ing from the lowest frequency and mov-
ing to the highest, then presets the
selected radio stations to the channels
sequentially, starting with 1.
You can preset up to 20 stations. The
preset stations will be automatically
sorted in frequency order.