Filter
Top Products
7
Before Using the CR-L5
1
Open the battery compartment, as
shown.
2
Insert the two supplied batteries (AA/
R6) in accordance with the polarity
diagram inside the battery compart-
ment.
3
Close the battery compartment.
Notes:
• The supplied batteries should last for about six months,
although this will vary with usage.
• If the remote controller doesn’t work reliably, try replac-
ing both batteries.
• Don’t mix new and old batteries, or different types of bat-
teries.
• If you intend not to use the remote controller for a long
time, remove the batteries to prevent possible leakage and
corrosion.
• Flat batteries should be removed as soon as possible to
prevent possible leakage and corrosion.
To use the remote controller, point it at the CR-L5’s remote
control sensor, as shown below.
Notes:
• The remote controller may not work reliably if the CR-L5
is subjected to bright light, such as direct sunlight or
inverter-type fluorescent lights. Keep this in mind when
installing the CR-L5.
• If another remote controller of the same type is used in
the same room, or the CR-L5 is installed close to equip-
ment that uses infrared rays, the remote controller may
not work reliably.
• Don’t put anything, such as a book, on the remote con-
troller, because the buttons may be pressed inadvertently,
thereby draining the batteries.
• The remote controller may not work reliably if the CR-L5
is installed in a rack behind colored glass doors. Keep this
in mind when installing the CR-L5.
• The remote controller will not work if there’s an obstacle
between it and the CR-L5’s remote control sensor.
Installing the Remote Controller
Batteries
Using the Remote Controller
D
I
S
P
L
A
Y
S
T
A
N
D
B
Y
/
O
N
P
H
O
N
E
S
D
I
R
E
C
T
M
E
M
O
R
Y
F
M
M
O
D
E
C
L
E
A
R
P
R
E
S
E
T
V
O
LU
M
E
S
P
E
A
K
E
R
S
A
/
B
ST
OP
PL
AY
PA
U
SE
I
N
P
U
T
T
U
N
I
N
G
S
T
A
ND
B
Y
30˚
30˚
CR-L5
Remote control
sensor
Approx. 5 m (16 ft.)