Onkyo CR-L5 CD Player User Manual


 
31
Troubleshooting—
Continued
Trouble Possible Cause Remedy
It takes a long time to locate
certain tracks?
The disc is dirty. Remove the disc and clean it (page 6).
The disc is very scratched. Buy a new disc.
The clock is wrong?
CT (Clock Time) information has been
taken from a radio station in another time
zone.
Set ACCUCLOCK to use a specific station
(page 17).
The CR-L5 turns itself on
unexpectedly?
The ACCUCLOCK function is updating the
clock.
This is not a malfunction. The CR-L5 will
turn itself off automatically when the ACCU-
CLOCK function has updated the clock.
The timer didn’t work?
The CR-L5 was already on at the specified
ON time.
Set the CR-L5 to Standby (page 27). The CR-
L5 must be in Standby mode, otherwise the
timed task will not work.
The specified ON time coincided, or over-
lapped the ON time of another timer.
Check the timer settings and correct as neces-
sary (page 28).
No sound is output when a
timed playback or record-
ing task starts?
While a timed recording task is in progress,
the output of the CR-L5 is muted.
To hear what’s being recorded, press the
[MUTING] button to cancel the Mute func-
tion. Press it again to mute the CR-L5.
For timed playback, the volume is deter-
mined by the VOLUME control.
Set the volume to a suitable level (page 19).
Abnormal Behavior
The CR-L5 contains a microcomputer for signal processing and control functions. In very rare situations, severe interfer-
ence, noise from an external source, or static electricity may cause it to lockup. In the unlikely even that this should happen,
unplug the power cord from the wall outlet, wait at least five seconds, and then plug it back in again.
Restoring the Default Settings
To reset the CR-L5 to its factory defaults, turn it on and, while holding down the STOP [ ] button, press the [STANDBY/
ON] button. Press the [STANDBY/ON] button again. “Initialized” appears on the display and the CR-L5 is reset to its
factory defaults.