Filter
Top Products
28
Timers—
Continued
You can turn timers on or off as necessary. This can be use-
ful when, for example, you’re on holiday and you don’t
want to be woken up by the timer that you normally use as
an early-morning radio alarm.
1
Press the [TIMER] button repeatedly
to select the timer that you want to
turn off.
In this example, timer #1 is selected.
2
Use the Up/Down [ ]/[ ] buttons to
select Timer Off.
The timer is turned off, and the previous display reap-
pears after two seconds.
To turn a timer back on again, repeat this procedure and
use the Up/Down [ ]/[ ] buttons to select Timer On.
You can check a timer’s settings as follows.
1
Press the [TIMER] button repeatedly
to select the timer that you want to
check.
In this example, timer #1 is selected.
2
Press the [ENTER] button repeatedly
to cycle through the timer’s settings.
Notes:
•You can edit the selected timer’s settings as you check
them. To do this, use the Up/Down [ ]/[ ] buttons to edit
the currently displayed setting, and then press [ENTER]
to move on to the next setting.
• If the selected timer was OFF, and you edit its settings, it
will be turned ON.
With the sleep timer you can set the CR-L5 so that it auto-
matically turns off after a specified period.
1
Press the [SLEEP] button repeatedly
to select the required sleep time.
With the [SLEEP] button you can set the sleep time
from 90 to 10 minutes in 10 minute steps.
While the sleep time is displayed, you can use the
remote controller’s Up/Down [ ]/[ ] buttons to set the
sleep time in 1 minute steps from 99 to 1.
The SLEEP indicator appears on the display when the
sleep timer has been set, as shown. The specified sleep
time appears on the display for about five seconds, then
the previous display reappears.
To cancel the sleep timer,
press the [SLEEP] button
repeatedly until the SLEEP indicator disappears.
To check the remaining sleep time,
press the
[SLEEP] button. Note that if you press the [SLEEP]
button while the sleep time is being displayed, you’ll
shorten the sleep time by 10 minutes.
Turning Timers Off
ON STANDBY
ENTER
TONE
TIMER
DIRECT
SLEEP VOLUME
UP
DOWN
CLOCK CALL
MUTING
12
▼
▲
3
456
789
▲
▼
INPUT
10/0
>
10
ENTER
TIMER
SLEEP
Checking Timer Settings
Using the Sleep Timer
SLEEP indicator