Filter
Top Products
20 SMART ANTENNA User Manual Rev 6
Chapter 3 Operation
Before operating the receiver for the first time, ensure that you have followed the installation instructions in
Chapter 2, Installation starting on Page 14. The following instructions are based on a configuration such as
that shown in Figure 12. It is assumed that a personal computer is used during the initial operation and testing
for greater ease and versatility.
Figure 12: Typical Operational Configuration
Reference Description
1 SMART ANTENNA
2 User-supplied PC
3COM1
4 COM2 (DGPS IN)
5 Power
6 Radio or rover station
7 External power source(s)
8 GPS signal
Your receiver must be a BASE model to act as a base station. A list of models may be found in Appendix A
of the SUPERSTAR II Firmware Reference Manual, see Reference [6] on Page 12.
7
2
3
4
5
6
8
1