Filter
Top Products
4
EnglishConnecting
Connecting
This chapter explains how to install your CLASSIK Movie Di and how to connect it to
speakers,TV etc.
Unpacking
The CLASSIK Movie Di is supplied with the following accessories:
●
luminescent handset with booklet
●
2 x R03 (AAA) size batteries for the handset
●
AM aerial
●
FM aerial
●
mains lead
●
this manual
We recommend that you retain all packaging in case you need to transport the CLASSIK
Movie Di at a later date.
Voltage selection
Do not connect the mains supply until you have verified that the CLASSIK Movie
Di is set to the correct voltage for your mains supply.
The CLASSIK Movie Di is factory-set for a 230 volt mains supply and must not be
connected to a mains supply other than this before it is adjusted for your local
voltage.To set the voltage, use a screwdriver to adjust the voltage selector on
the rear of the unit to the correct setting.
This appliance must be earthed. Use the earthed moulded mains lead supplied.
Never use an unearthed plug or adapter.
Positioning
You can position your CLASSIK Movie Di almost anywhere you find convenient, but
please consider the following points:
●
Allow at least 10cm of space to the sides, rear and above the CLASSIK Movie Di for
air circulation.
●
Never block the ventilation holes on the top and sides of the unit.
●
The handset is sensitive.You should have no problems operating the CLASSIK
Movie Di with the handset wherever it is placed in a room, provided you keep the
CLASSIK Movie Di out of direct sunlight and you do not obscure the control
window.
IMPORTANT:
Do not open the CLASSIK Movie Di’s disc drawer if the unit is behind glass doors as this
can damage the drawer’s mechanism.
Mains supply range Setting on voltage selector
90V – 126V 115V
207V – 253V 230V