Filter
Top Products
51
www.remotepossibilities.com
Output #1
PRESENT SETTINGS
======= ========
1 = Label <Label>
2 = On Time per Minute 60
3 = Control Mode Manual
4 = Power-up State OFF
5 = Alarm Mask FF
0 = Previous Menu
Choose a Number>
Enter New Label>Heater
On-Time per Minute
This parameter can be used to 'throttle' an output (rather than have it constantly on or off). If an output has
been turned on, and this parameter is set for 40, then the output will cycle on for 40 seconds and off for 20
seconds (ad infinitum). If the parameter is set for 60, the output remains on constantly. The minimum value
is one. The default value is 60 seconds.
COMMAND>OUT S
SET/CHECK OUTPUT SETTINGS
========= ====== ========
1 = Output #1 Heater
2 = Output #2 <Label>
3 = Output #3 <Label>
4 = Output #4 <Label>
0 = Previous Menu
Choose a Number>1
Output #1
PRESENT SETTINGS
======= ========
1 = Label <Label>
2 = On Time per Minute 60
3 = Control Mode Manual
4 = Power-up State OFF
5 = Alarm Mask FF
0 = Previous Menu
Choose a Number>2
Enter New Value> 20
Control Mode
See Controlling Outputs for description of control modes.