Filter
Top Products
Calibration Utility for MACINTOSH
2–21
Part No. 1H9659 September 1997
Using an Existing Calibration Table as the Starting Point
You can follow the steps below only if you have previously created and
saved a calibration table. If you are using the Calibration Utility for the
first time, no calibration tables exist yet for use as a starting point.
The table you select to use as a starting point does not contain printer
setup information. Follow the instructions in “Selecting and Setting Up
a Printer” on page 2–16 to specify information about the printer paper
and media.
1. Select the
Copy Table from File:
radio button in the
Starting Point
box.
2. Click on the
Select File...
button.
A file selection dialog box appears.
3. Find and open the folder that contains the calibration table you want
to use as the starting point for your new table.
4. Select the calibration table you want to copy.