Filter
Top Products
Calibration Utility for MICROSOFT WINDOWS
1–28
September 1997 Part No. 1H9659
Using the Calibration Document Window
Use the Calibration Document window to set up and run Visual Gray
Balance, Visual Linearity, and Densitometer calibrations.
1. Make sure that the information in the
Printer Setup Information
box is correct and make sure that you are creating a calibration
table for the media you want to use.
2. Type information about the printer you are calibrating in the
Printer
Description
text box.
3. Type information about the media combination for which you are
calibrating in the
Media Description
text box.
NOTE: Entries in the
Printer Description
and
Media Description
text
boxes are optional and do not appear on the test print.
You can calibrate your printer. Refer to “Calibrating the Printer”
on page 1–29.
NOTE: If you are using black-only media, you cannot use the Visual Gray
Balance calibration method to calibrate your printer. You must go
directly to the Visual Linearity calibration procedure.