Kenwood MDX-G3 Stereo System User Manual


 
59
EN
Application
section
Timer
7 Execution
7
Press the TIMER key on the re-
mote repeatedly until the pro-
gram number to be executed
("PROG.
1
" or "PROG.
2
" or
"PROG.
12
") is lit.
8
Press the POWER key to
switch the power off to the
STANDBY mode.
The STANDBY/TIMER indicator lights
in green.
The program timer is activated and re-
cording will start when the set ON time
comes.
Program No. lit
To cancel program timer :
Press the TIMER key on the remote re-
peatedly until "PROG.1" or "PROG.2" or
"PROG.12" turns off.
To check or change the timer setting :
Restart the procedure from step 1 again.
÷ Be sure to adjust the time of the day (page 7)
before using the timer functions.
÷ PROG.1 and PROG.2 should be set so that
their operating periods do not overlap. Leave
at least 1 minute of interval between the two
programs.
÷ The speakers do not output audio during
timer recording.
÷ Even when the program timer is canceled,
previously made setting is stored in memory
and remains until new timer information is
set the next time.
÷ When the STANDBY/TIMER indicator is
blinking in green, the timer setting or clock
setting is erroneous. Check and correct them
as required (pages 7 & 58).
1
EX. BASS
TUNER