Filter
Top Products
4
EN
System connection
POWER cord (1) Remote control unit (1) Batteries(R6/AA)
for remote (2)
AM loop antenna (1)
Loading batteries in the remote control unit
÷ The provided batteries are intended for use in operation checking, and their service life may be
short.
÷ When the remote-controllable distance becomes short, replace both of the batteries with new
ones.
÷ If direct sunlight or the light of a high-frequency fluorescent lamp (inverter type, etc.) is incident to
the remote sensor on the main unit front panel, malfunction may occur. In such a case, change the
installation position to avoid malfunction.
÷ When pressing more than one remote control keys successively, press each key securely by
leaving an interval of 1 second or more between keys.
÷ The standard remote-control range is within about 6 meters from the main unit front panel. Be
sure to point the remote to remote sensor on the front panel.
(3) Attach the battery com-
partment cover.
(2) Insert two R6("AA"-size) batter-
ies following the polarity indi-
cations.
(1) Remove the battery com-
partment cover of the re-
mote.
Unpacking
Unpack the unit carefully and make sure that all the accessories are present.
If any accessories are missing, or if the unit is damaged or fails to operate, notify your dealer
immediately. If the unit was shipped to you directly, notify your shipper immediately. Kenwood
recommends that you retain the original carton and packing materials in case you need to
move or ship the unit in the future.
Keep this manual handy for future reference.
remote sensor