Filter
Top Products
Memory backup function
Please note that the following items will be deleted from
this unit's memory if the power cord is disconnected
from the AC outlet for approximately three days.
• ]'he input selection is cleared and the "Tuner" nput is selected.
• The volume setting is cleared and the volume is set to "-66 dB",
• The receiving band setting is cleared and the "FM" bend _s
selected.
VR- 2090/VR-2080/KRF-V8881 D/KRFoV77710 (EniK}
• The frequency setting is cleared and 875 MHz is selected.
• The preset station memory is cleared,
• The surround setting is cleared and reset to the initial condition
Remotecontrol unit
Remote control operation is not possible,
• Batteries are exhausted
• The remote control unit is ;oo far away from the
main system, controlling angle is too large, or
there is an obstac e in between.
• The audio cords and system control cords are
not connected properly.
• The source component to be operated does not
contain the tapeIs] or disc
• Reprace with new batteries,
• Operate the remote control unit within the
controllable range,
• Connect properly referring to "System con-
nection",
• Pace the tape(s) or disc in the source compo
nent to be played,
The RC screen is not displayed. • Batteries are exhausted, • Replace with new batteries,
The RC display is abnormal. • Batteries are removed while something is dis- • Remove and replace batteries after th,e infer-
played matron display has disappeared.
Setup Codes chart
Although each setup code is designed to work with a number of different models, certain codes may not work with some
models. (Also, certain codes may only operate some of the functions available on a given model.}
With some models, be sure to keep the ENTER key pressed for a while.
Inquiries on the setup codes loaded using the Free-Phone Consumer Help Line:
If there is any inquiry related to these setup codes, please contact the following services.
U.S.A. : 1-800-753-9860 Canada : 1-800-644-0073
For the UoS.A.
FCC WARNING
This equipment may generate or use radio frequency energy Changes or modifications to this equtpment may cause harmful interference unless
the mod]ficatons are expressly approved in the instruction manual. The user could lose the authority to operate this equipment f an
unauthorized change or rood fication is made.
NOTE:
This equipment has been tested and found to comply with the Imits for a Cass B digital device, pursuant to Part 15 of the FCC Rules. Ihese
limits are designed to provide reasonable protection against harmful interference m a residential installation. This equipment may cause
harmful interference to radio communications, if it is not installed and used in accordance with the instructions However. there is no
guarantee that interference will not occur in a particu ar installation. If this equipment does cause harmful eterference to radio or telev sion
reception, which can be determined by turning the equipment off and on, the user s encouraged to try to correct the interference by one
or more of the following measures:
-- Reorient or relocate the recewrng antenna.
-- Increase the separation between the equipment and receiver
-- Connect the equipment into an outlet on a circuit different from that to which the receiver _s connected.
-- Consult the dealer or an experienced radio / TV technic an for help.
For the U.S.A,
Note to CATVsysteminstaller:
This reminder is provided to oall the CAW systeminstallnr's attenbon to Article 820-40 of the NEC that provides guideIines far proper
grounding and, in particular, specifies that the cabe ground shall be connected to the grouoding system of the building, as cose to the point
of cable entry as practical j
Do not use contact cleaning agents because they could case a malfunction Be specifically careful against using contact cleaning agentscontaining oil, since they may deform the plastic components.