Kenwood KRF-V8881 D Stereo Receiver User Manual


 
To control the system components in "Room A" from "Room
B", it is first required to set the IR RECEIVER to "Room B".
After this, perform the IR RECEIVER setup using the main
unit keys as described in "Switching the IR RECEIVER mode",
Then, perform the required setups for the remote control
unit using its "Setup Multi Room" menu as described below.
After the "Room B" operation has been set, the audio for
"Room B" is output from the speakers connected to the
SPEAKERS B terminals and from the speakers of the power
amplifier connected to the PREOUT jacks.
VR_2OgOIVR-2080/KRF-V88 B 1OiKRF V777 ! D (En,/KI
D Se/ect the "Main Menu" icon from the fixed segments.
[ Lstn ;Mode TSndTFnc[S t p=]
The menu screen shown in step [] is displayed when [he "Stp"
icon s selected from the "Main Menu"
Perform icon selection in the "Setup" menu.
O Select the "Multi Room" icon in the "Setup" menu.
Download Multi Room
Back
Perform setup.
Zone Select
DISPLAY MODE
To control the des] red com-
ponents from another
room, be sure [o set [he
remote control unit to the
"Room B" control mode
O Setup of the remote control unit,
Multi Room : Yes/No
.................. Select "Yes" to use the system in both
"Room A" and "Room B".
Zone Select : Room A/Room B
.................. Set according to your current location.
.................. Select "Room A" if you are located in Room A.
.................. Select "Room B" if you are located in Room B,
While "Multi Room" is set to "Yes", pa_rt of the system contm
operation, wMch is a "SL16" function, is not avaiiable
I_ Setup of the main unit,
Press and hold the DISPLAY MODE key for more than 2
seconds to set the IR RECEIVER setup to "IR RECEIVER B',
I To cor_trol components from "Room B"....
See the description of "Remote control of audio in another
room {Room B}" l
s When "Zone Select" is set _o "Room B", only the "Setup" menu
can be selected from the "Main Menu" screens,