Filter
Top Products
English
— 56 —
MP3/WMA source
? Cannot play an MP3/WMA.67
✔ The media is scratched or dirty.69
☞ Clean the media, referring to the CD cleaning of the section on
<About CDs> (page 9).
? The sound skips when an MP3/WMA is being played.73-1
✔ The media is scratched or dirty.
☞ Clean the media, referring to the CD cleaning of the section on
<About CDs> (page 9).
✔ The recording condition is bad.73-2
☞ Record the media again or use another media.
? The MP3/WMA track time isn’t displayed correctly.80
✔ ---
☞ There are times when it isn’t displayed correctly according to the
MP3/WMA recording conditions.
If the following situations, consult your nearest service
center:
Even though the disc changer is connected, the Disc Changer source is not
ON, with "AUX1" showing in the display during the Changer Mode.
The messages shown below display your systems
condition.
Eject: No disc magazine has been loaded in the changer. The disc
magazine is not completely loaded.E01
➪ Load the disc magazine properly.
No CD in the unit.
➪ Insert the CD.
No Disc: No disc has been loaded in the disc magazine.E02
➪ Load a disc into the disc magazine.
TOC Error: No disc has been loaded in the disc magazine.E04
➪ Load a disc into the disc magazine.
The CD is quite dirty. The CD is upside-down. The CD is
scratched a lot.
➪ Clean the CD and load it correctly.
E-05: The CD is upside-down.E05
➪ Load the CD correctly.
Blank Disc: Nothing has been recorded on the MD.E10
No Track Disc: No tracks are recorded on the MD, although it has a title.E11
E-15: Media was played that doesn’t have data recorded that the
unit can play. E15
➪ Use media that has data recorded that the unit can play.
No Panel: The faceplate of the slave unit being connected to this unit
has been removed.E30
➪ Replace it.
E-77: The unit is malfunctioning for some reason.E77
➪ Press the reset button on the unit. If the "E-77" code does
not disappear, consult your nearest service center.
Mecha Error: Something is wrong with the disc magazine. Or the unit is
malfunctioning for some reason.E99
➪ Check the disc magazine. And then press the reset button
on the unit. If the "Mecha Error" code does not disappear,
consult your nearest service center.
E-99: The unit is malfunctioning for some reason.E99A
➪ Press the reset button on the unit. If the "E-99" code does
not disappear, consult your nearest service center.
Troubleshooting Guide
KDC-X969_U.S_r4.pg 02.12.13 4:45 PM Page 56