Filter
Top Products
Adjustment Item Button Display
The panel tilts upwards [2] "ANG–"
The panel tilts downwards [3] "ANG+"
The panel slides backward [4] "SLD–"
The panel slides forward [5] "SLD+"
4 Exit Panel Position Setting mode
Press the [RTN] button.
The control panel may be interfered with the shift lever or another
part depending on the angles of the control panel.
Set the angle to avoid any interference.
No sound is produced while the panel is operating.
Setting the angle or back-forward position of the control panel.
1 Select the key function section
Press the [NEXT] button.
Repeatedly press the button until "PNL" is displayed above the [4]
button.
2 Enter Panel Position Setting mode
Press the [4] ("PNL") button.
3 Select the item for adjustment
Press the desired [2] — [5] button.
Each time the button is pressed the items that can be adjusted
switch as shown below.
Panel Position Setting
Turning the volume down quickly.
Press the [ATT] button.
Each time the button is pressed the Attenuator turns ON or OFF.
When it’s ON, "ATT ON" is displayed.
Attenuator
— 11 —
Increasing Volume
Turn the [VOLUME CONTROL] knob clockwise.
Decreasing Volume
Turn the [VOLUME CONTROL] knob counterclockwise.
Volume
KDC-X969_U.S_r5.pg 03.1.6 10:27 AM Page 11