Filter
Top Products
58
Operating Other Manufacturers’ Equipment
This remote control supplied with the receiver can transmit control signals for other manufacturers’ VCRs, TVs, CATV
converters, DBS tuners and DVD players. By changing the transmittable signals from preset ones to the other
manufacturers’, you can operate the other manufacturer’s components using this remote control.
IMPORTANT:
When using the remote control:
–Set the TV operation mode selector to “TV” or
“CATV/DBS” correctly.
To operate TV, set it to “TV.”
To operate the CATV converter or the DBS tuner, set it
to “CATV/DBS.”
–Check the indication shown on the remote’s display when you press
a button—this indicates the remote control operation mode for a
while (10 or 5 seconds).
TV
CATV/
DBS
STANDBY/ON STANDBY/ON
STANDBY
TV/CATV/DBS
VCR 1
ON
Ex.When you press VCR1.
CAUTION:
When replacing the batteries, finish it without delay; otherwise,
manufactures’ codes are lost.
Changing the Preset Signal Codes
By changing the transmittable signals from preset ones to the other
manufacturers’, you can operate the other manufacturer’s
components using this remote control.
• When operating the other manufacturers’ components, refer also
to the manuals supplied with them.
To change the transmittable signals for
operating another manufacturer’s TV
1. Set the TV operation mode selector to
“TV.”
2. Press and hold TV/CATV/DBS
(STANDBY/ON).
TV/CATV/DBS
STANDBY/ON
TV
CATV/
DBS
3. Press TV/DBS.
4. Enter manufacturer’s code
using buttons 1–9, and 0.
See page 61 to find the code.
5. Release TV/CATV/DBS (STANDBY/ON).
After setting the TV operation mode selector to “TV,” you can
perform the following operations on the TV:
TV/CATV/DBS
(STANDBY/ON) :
Turns on or off the TV.
TV VOL +/– : Adjusts the volume.
TV/VIDEO : Sets the input mode (either TV
or VIDEO).
After pressing TV/DBS (with the TV operation mode selector
set to “TV”), you can perform the following operations on a TV:
CHANNEL +/– : Changes the channels.
1 – 10, 0, 100+ (+10): Selects the channels.
Number button 10 will function as the
ENTER button if your TV requires
pressing ENTER after selecting a
channel number.
Notes:
• Refer to the manual supplied for your TV.
• All the functions listed above may not be assigned to the
buttons for some TVs.
• If you cannot change the channels of some TVs by pressing
number buttons, press CHANNEL +/– for changing the channels.
6. Try to operate your TV by pressing
TV/CATV/DBS
(STANDBY/ON).
When your TV turns on or off, you have entered
the correct code.
If there are more than one code listed for your brand of TV,
try each one until the correct one is entered.
TV/DBS
Remote’s display
EFFECT
ROOM SIZE
FM MODE
RETURN
100
+
WALL
LIVENESS
123
456
7
/P
89
10
+
100
TV/CATV/DBS
STANDBY/ON
EN53-64_RX-DP9VBK[J]_f 01.6.14, 10:07 AM58