Filter
Top Products
20
DIGITAL AUTO: Select this for the digital input mode.
The receiver automatically detects the
incoming signals.
The DIGITAL AUTO indicator lights up on
the display, and the digital signal format
indicators for the detected signals also light
up.
ANALOG : Select this for the analog input mode.
The ANALOG indicator lights up.
When selecting “DIGITAL AUTO,” the following indicators
indicate the digital signal format of the incoming signal.
LINEAR PCM
: Lights up when Linear PCM signals come in.
DIGITAL
: Lights up when Dolby Digital or Dolby Digital
EX signals come in.
: Lights up when DTS Surround or DTS-ES
signals come in.
No indicator lights up when the receiver cannot recognize the
digital signal format of the incoming signals.
When playing a software encoded with the Dolby Digital or DTS
Surround, the following symptoms may occur:
• Sound does not come out at the beginning of playback.
• Noise comes out while searching for or skipping chapters or
tracks.
In this case, press RIGHT (or LEFT) on the unit to select “DOLBY
DIGITAL” or “DTS” while “DIGITAL AUTO” still remains on the
display.
• Each time you press the button, the input mode changes as
follows:
When “DOLBY DIGITAL” or “DTS” is selected, the DIGITAL
AUTO indicator goes off, and the corresponding digital signal
format indicator (
DIGITAL
or ) lights up on
the display.
• If the incoming signal does not match the selected digital signal
format, the frame of the selected indicator will flash.
Note:
When you turn off the power or select another source, “DOLBY
DIGITAL” and “DTS” settings are canceled and the digital input mode
is automatically reset to “DIGITAL AUTO.”
L
DIGITAL AUTO
ANALOG
DIGITAL
SPEAKERS
VOLUME
1
SUBWFR
R
LFE
RSLS
dB
DIGITAL AUTO
DOLBY DIGITAL DTS
DVD DVD MULTI VCR 1 VCR 2 TV/DBS CDVIDEO PHONO TAPE/MD CDR FM AM
On the unit
On the remote control
DVD
DVD MULTI
CD
CDR
PHONO
TAPE/MD
AM
VCR 1 VCR 2
FMVIDEOTV/DBS
INPUT MODE
On the remote control
On the unit
(inside the front door)
ANALOG/DIGITAL
INPUT
L
ANALOG
SPEAKERS
VOLUME
1
SUBWFR
R
dB
L
DIGITAL AUTO
DIGITAL
SPEAKERS
VOLUME
1
SUBWFR
R
LFE
RSLS
dB
Selecting the Analog or Digital Input
Mode
When you have connected digital source components using the
digital terminals (see page 14), you need to select the digital input
mode.
Before you start, remember...
The digital input (DIGITAL IN) terminal setting should be
correctly done for the sources you want to select the digital input
mode for (see “Setting the Digital Input Terminals—DIGITAL
IN” on page 32). Without setting this digital input terminal
correctly, you cannot change the input mode from analog input to
digital input even if you follow the procedure below.
1. Press one of the source selecting buttons (DVD,
VCR1, TV/DBS, CD, CDR, or TAPE/MD)* for
which you want to change the input mode.
Note:
* You can select the digital input only for the sources which you
have selected the digital input terminals for. (See “Setting the
Digital Input Terminals—DIGITAL IN” on page 32.)
In addition, when “TAPE” has been assigned as the source
name to the TAPE/MD button, it does not work in this step.
To change the source name, see “Changing the Source Name”
on page 22.
2. Press INPUT MODE (or ANALOG/DIGITAL
INPUT) to change the input mode.
• Each time you press the button, the input mode changes as
follows:
EN16-23_RX-DP9VBK[J]_f 01.6.14, 9:51 AM20