Filter
Top Products
22
Changing the Source Name
When you have connected an MD recorder to the TAPE/MD jacks
or the DBS tuner to the TV SOUND/DBS jacks on the rear panel,
change the source name which will be shown on the display when
you select the MD recorder or DBS tuner as the source.
On the unit ONLY:
When changing the source name from “TAPE” to
“MD”:
1. Press TAPE/MD.
2. Press and hold TAPE/MD until
“ASSGN. MD” appears on the display.
When changing the source name from “TV ” to
“DBS”:
1. Press TV/DBS.
2. Press and hold TV/DBS until “ASSGN.
DBS” appears on the display.
To change the source name to “TAPE” or “TV,” repeat the same
procedure above — press and hold TAPE/MD to select “TAPE,” or
press and hold TV/DBS to select “TV” in step 2.
Note:
Without changing the source name, you can still use the connected
components. However, there may be some inconvenience.
– “TAPE” or “TV” will appear on the display when you select the MD
recorder or DBS tuner.
– You cannot use the digital input (see page 20) for the MD recorder.
– You cannot use the COMPU LINK remote control system (see page
47) to operate the MD recorder.
Making Sounds Natural
JVC’s CC (Compensative Compression) Converter eliminates jitter
and ripples, achieving a drastic reduction in digital distortion by
processing the digital music data in 24 bit–quantization and by
expanding the sampling frequency to 176.4 kHz (for fs 44.1 kHz
signals)/192 kHz (for fs 48 kHz signals).
By using the CC Converter, you can obtain a natural sound field
from any source.
Press CC CONVERTER so that the CC
CONVERTER lamp lights up.
• Each time you press the button, CC Converter turns on and off (the
lamp goes off) alternately.
Note:
You cannot use this function while Line Direct or THX Surround is in
use. If you turn on Line Direct or THX Surround while this function is
in use, this function will be canceled.
Changing the Display Brightness
You can dim the display.
Press DIMMER.
• Each time you press the button, the brightness level of the display
changes as follows:
Note:
Even though the dimmer is in use, the display brightens for a while
when you operate the receiver (except when changing the source).
CC CONVERTER
CC CONVERTER
On the unit
On the remote control
TAPE/MD
L
ANALOG
SPEAKERS
VOLUME
1
SUBWFR
R
dB
L
ANALOG
SPEAKERS
VOLUME
1
SUBWFR
R
dB
TV/DBS
On the remote control
DIMMER
Dimmer Much dimmer
Canceled
(Normal display)
On the unit
DIMMER
EN16-23_RX-DP9VBK[J]_f 01.6.14, 9:51 AM22