Filter
Top Products
23
Recording a Source
For analog-to-analog recording
You can record any analog source through the receiver to—
• the cassette deck (or MD recorder) connected to the TAPE/
MD jacks,
• the VCRs connected to the VCR 1 and VCR 2 jacks, and
• the CD recorder connected to the CDR jacks
— at the same time.
For digital-to-digital recording
You can record the currently selected digital input source
through the receiver to a digital recording device connected to
the DIGITAL OUT terminal.
Notes:
• Analog-to-digital and digital-to-analog recordings are not
possible.
• All sound adjustments cannot affect the recording.
• The test tone signal (see pages 37 and 42) does not come out
through the DIGITAL OUT terminal.
IMPORTANT:
While recording, do not turn off the receiver source; otherwise,
recording will stop.
Basic adjustment auto memory
This receiver memorizes sound settings for each source—
• when you turn off the power,
• when you change the source,
• when you change the analog/digital input mode (see page 20),
and
• when you turn on One Touch Operation (see page 33).
When you change the source, the memorized settings for the
newly selected source are automatically recalled.
The following can be stored for each source:
• Analog/digital input mode (see page 20)
• Input attenuator mode (see page 21)
• Line Direct (see page 21)
• Midnight mode (see page 31)
• Speaker channel output levels (see page 37)
• Parametric Equalizer setting (see page 37)
• DSP Parameters (see page 38)
• THX Surround On/Off setting (see page 41)
• Surround mode On/Off setting (see page 41)
• DSP mode selection (see page 44)
Notes:
• If the source is FM or AM, you can assign a different setting for
each band.
• If you want to memorize the volume level together with the
above setting, set “ONE TOUCH OPERATION” to “ON” (see
page 33).
Using the Sleep Timer
Using the Sleep Timer, you can fall asleep to music and know the
receiver will turn off by itself rather than play all night.
From the remote control ONLY:
Press SLEEP repeatedly.
The SLEEP indicator lights up on the display, and the
shut-off time changes as follows (in minutes):
When the shut-off time comes
The receiver turns off automatically.
To check or change the time remaining until the shut-off time
Press SLEEP once.
The remaining time until the shut-off time appears in minutes.
• To change the shut-off time, press SLEEP repeatedly.
To cancel the Sleep Timer
Press SLEEP repeatedly until “SLEEP 00min.” appears on the
display. (The SLEEP indicator goes off.)
• Turning off the power also cancels the Sleep Timer.
SLEEP
L
ANALOG
SLEEP
SPEAKERS
VOLUME
1
SUBWFR
R
dB
Ex. When the source is “VIDEO.”
2010 30 40 50 60 70 80 90
(Canceled)
00
EN16-23_RX-DP9VBK[J]_f 01.6.14, 9:51 AM23