JVC RX-7040B Stereo System User Manual


 
7
Connecting the Speakers and Subwoofer
You can connect the following speakers:
Two pairs of front speakers.
One pair of surround speakers.
One surround back speaker or one pair of surround back speakers.
One center speaker.
One powered subwoofer.
CAUTION:
Use only the speakers of the SPEAKER IMPEDANCE indicated by
the speaker terminals.
When connecting to either the FRONT SPEAKERS 1 or 2
terminals, use speakers with an impedance of 8 to 16 .
When connecting to both of the FRONT SPEAKERS 1 and 2
terminals, use speakers with an impedance of 16 to 32 .
Do not connect more than one speaker to each speaker terminal.
IMPORTANT:
After connecting the speakers, set the speaker installation
information properly. You can use Quick Speaker Setup for it (see
page 21).
To obtain the best possible Surround/DSP effect, see Setting the
Speakers on page 23.
*
2
When using only one surround back speaker, connect the
ª
cord to the RIGHT
ª
terminal and the
·
cord to the LEFT
·
terminal.
To LEFT · terminal
RIGHT
LEFT
+
CAUTION : SPEAKER IMPEDANCE
SURROUND BACK SPEAKERS
SINGLE USE
See Instruction
Manual For
Connection
S
U
8
R
To RIGHT ª terminal
Connecting the subwoofer
You can enhance the bass by connecting a subwoofer.
Connect the input jack of a powered subwoofer to the rear panel,
using a cable with RCA pin plugs (not supplied).
SUBWOOFER
OUT
123
Speaker connections
1. Twist and remove the insulation at the end of
each speaker signal cable (not supplied).
2. Open the speaker terminal.
3. Insert the speaker signal cable.
4. Close the speaker terminal.
For each speaker (except for a subwoofer), connect the (+) and
(–) terminals on the rear panel to the (+) and (–) terminals
marked on the speakers.
4
Front speakers 1
Right / Left
Surround back speakers
*
2
Right / Left
Front speakers 2
Right / Left
Center speaker
Surround speakers
Right / Left
RIGHT
LEFT
+
+
12
CENTER
SPEAKER
SURROUND SPEAKERS
816
CAUTION : SPEAKER IMPEDANCE
SURROUND BACK SPEAKERS
RIGHT
LEFT
RIGHT
LEFT
RIGHT
LEFT
CAUTION : SPEAKER IMPEDANCE
SINGLE USE
See Instruction
Manual For
Connection
1
OR
2 :
8
16
1
AND
2 :
16
32
+ +
FRONT SPEAKERS
*
1
*
1
For FRONT
SPEAKERS
2
terminals
Surround back speaker
Powered Subwoofer
RIGHT
LEFT
+
RIGHT
LEFT
RIGHT
LEFT
+
RIGHT
LEFT
RIGH
T
LEFT
+
RIGHT
LEFT
01-12_7040[J] 04.1.21, 15:547