Filter
Top Products
42
Operating Other Manufacturers’ Video Equipment
This remote control supplied with the receiver can transmit control signals for other manufacturers’ TVs, CATV
converters, DBS tuners, VCRs and DVD players.
When operating the other manufacturers’ components, refer also to
the manuals supplied with them.
• After replacing batteries for the remote control, you need to set
the manufactures’ codes again.
To change the transmittable signals for
operating another manufacturer’s TV
1. Press and hold TV .
2. Press TV/DBS.
3. Enter a manufacturer’s code using buttons 1 – 9,
and 0.
See the list on page 44 to find the code.
4. Release TV .
5. Try to operate your TV by pressing TV
.
When your TV turns on or off, you have entered the correct
code.
If there are more than one code listed for your brand of TV,
try each one until the correct one is entered.
The following buttons can be used for operating the TV:
TV
: Turn on and off the TV.
TV VOL +/–: Adjust the volume.
TV/VIDEO: Set the input mode (either TV or VIDEO).
After pressing TV/DBS, you can perform the following
operations on the TV:
CHANNEL +/–: Change the channels.
1 – 9,10 (RETURN), 0, 100+ (+10):
Select the channels.
The 10 (RETURN) button will function as the
ENTER button if your TV requires pressing
ENTER after selecting a channel number.
Notes:
• All the functions listed above may not be assigned to the buttons for
some TVs.
• If you cannot change the channels of some TVs by pressing
10 keys, press CHANNEL +/– for changing the channels.
To change the transmittable signals for
operating a CATV converter or DBS tuner
1. Press and hold CATV/DBS .
2. Press CATV/DBS CONT.
3 Enter a manufacturer’s code using buttons 1 – 9,
and 0.
See the list on page 44 to find the code.
4. Release CATV/DBS .
5. Try to operate your CATV converter or DBS
tuner by pressing CATV/DBS
.
When your CATV converter or DBS tuner turns on or off, you
have entered the correct code.
If there are more than one code listed for your brand of
CATV converter or DBS tuner, try each one until the correct
one is entered.
The following button can be used for operating the CATV
converter and DBS tuner:
CATV/DBS
: Turn on and off the CATV converter or DBS
tuner.
After pressing CATV/DBS CONT, you can perform the
following operations on the CATV converter or DBS tuner:
CHANNEL +/–: Change the channels.
1 – 9,10 (RETURN), 0, 100+ (+10):
Select the channels.
The 10 (RETURN) button will function as
the ENTER button if your equipment
requires pressing ENTER after selecting a
channel number.
Note:
You cannot preset the signals for both the CATV converter and DBS
tuner at the same time.
38-46_7040[J] 04.1.21, 15:5542