Filter
Top Products
27
English
Adjusting Sound
You can make sound adjustment to your preference after completing basic setting.
Basic Adjustment Items
On the following pages, you can adjust the items listed below:
• You can adjust only the items applicable to the current sound
mode.
• If Analog Direct is in use, you cannot make any sound
adjustments.
Items To do See page
EQ 63Hz Adjust equalizer pattern at 63 Hz. 28
EQ250Hz Adjust equalizer pattern at 250 Hz. 28
EQ 1kHz Adjust equalizer pattern at 1 kHz. 28
EQ 4kHz Adjust equalizer pattern at 4 kHz. 28
EQ16kHz Adjust equalizer pattern at 16 kHz. 28
SUBWFR LVL Adjust the subwoofer output level. 28
FRNT L LVL Adjust the left front speaker output
level. 28
FRNT R LVL Adjust the right front speaker output level. 28
CENTER LVL Adjust the center speaker output level. 28
SURR L LVL Adjust the left surround speaker output
level. 28
SURR R LVL Adjust the right surround speaker output
level. 28
SBACK LVL Adjust the surround back speaker(s)
output level. 28
EFFECT*
1
Adjust the effect level. 29
ROOMSIZE*
1
Select the room size for your virtual
listening room. 29
LIVENESS*
1
Select the liveness level for your
virtual listening room. 29
CTR TONE Make the center tone soft or sharp. 29
PNRM CNTRL*
2
Add “wraparound” sound effect with
side-wall image. 29
CNTR WIDTH*
2
Adjust the center channel localization
between the center speaker and the
left/right front speakers. 29
DIMENSION*
2
Adjust sound localization position. 29
CNTR GAIN*
3
Adjust sound localization of the
center channel. 29
Notes:
*
1
Adjustable when one of the DAP modes or Mono Film (see pages
34 and 35) is in use.
*
2
Adjustable when Pro Logic II Music (see page 31) is in use.
*
3
Adjustable when Neo:6 Music (see page 31) is in use.
LINEAR PCM
L
SUBWFR
R
ANALOG
VOLUME
SPEAKERS 1
LINEAR PCM
L
SUBWFR
R
ANALOG
VOLUME
SPEAKERS 1
LINEAR PCM
L
SUBWFR
R
ANALOG
VOLUME
SPEAKERS 1
LINEAR PCM
L
SUBWFR
R
ANALOG
VOLUME
SPEAKERS 1
Basic Procedure
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
Ex. When adjusting the subwoofer level to “–3.”
1. Press ADJUST.
The last selected item appears on the display.
2. Turn MULTI JOG until an item you want
appears on the display.
• In this example, select “SUBWFR LVL.” For available items,
see the list “Basic Adjustment Items.”
3. Press in MULTI JOG (PUSH SET).
The current setting (or level) for the selected item appears on the
display.
4. Turn MULTI JOG to select a setting you want or
to make an adjustment as you like.
5. Press in MULTI JOG (PUSH SET).
6. Repeat steps 2 to 5 to set other items if necessary.
7. Press EXIT.
The source indication resumes on the display.
27-29_7040[C] 04.2.12, 19:0127