Filter
Top Products
– 15 –
English
Basic Disc Playback
Loading Discs
1
Press 0.
The unit automatically turns on and the
carrousel comes out.
2
Place one or two discs correctly on the front
slots of the carrousel, with its label side up.
• When using a CD single (8 cm), place it on the inner
circle of the disc tray.
• Continued use of irregular shape CDs (heart-shape,
octagonal, etc.) can damage the unit.
3
If you wish to load a third disc,
press DISC CHANGE on the unit
or DISC SKIP on the remote
control.
The carrousel rotates by 120˚.
4
Press 0 again.
The carrousel closes.
About the disc indicators
Each disc indicator corresponds to the disc tray of the same number.
• The disc marker lights up for the disc number you have selected.
• The disc indicator rotates while the corresponding disc is being
played.
• The disc indicator goes off when the unit has detected that there is
no disc on the corresponding disc tray.
Playing Back the Entire Discs — Continuous
Play
You can play discs continuously.
• While playing a DVD or VCD with the PBC function
loaded on the disc trays, the continuous play will stop when
a disc menu appears. If a menu appears while playing a
DVD or VCD with PBC function, see “Menu-Driven
Playback” on page 20.
1
Load discs.
2
Press one of the disc number
buttons (DVD1, DVD2, and
DVD3) for the disc you want to
play.
Disc play starts from the first chapter or
track of the selected disc.
• Pressing DVD 6 instead of the disc number buttons
starts playing back if a disc is on the trays.
To stop during play, press 7.
• If you are playing back a disc, this unit can memorize the
end point even when you turn off the unit, and when you
start playback again by pressing DVD 6, playback
begins from where it has been stopped. (Resume play)
• To stop completely, press 7 twice.
To remove the disc, press 0.
Disc playback sequence during Continuous play
When 3 discs are loaded on the disc trays, they are played in one of
the following sequences.
• When DVD1 is pressed : DVD1 ] DVD2 ] DVD3 (then stops)
• When DVD2 is pressed : DVD2 ] DVD3 ] DVD1 (then stops)
• When DVD3 is pressed : DVD3 ] DVD1 ] DVD2 (then stops)
* When only 2 discs are loaded, they are played in the same order,
but the disc tray without a disc is skipped.
CORRECT
INCORRECT
Disc number
Disc indicator
Disc marker
DISC CHANGE
Chapter (or title) number (DVD)
Track number (VCD, CD)
Elapsed playing time
Chapter (or track) number of the currently
playing disc is flashing. (Numbers exceeding
16 are not displayed.)
Before playing a DVD or VCD, select the color system as
indicated on the disc.
On the unit only:
Press TAPE A while the unit is in standby mode.
Each time you press the button, “PAL,”
“NTSC,” and “SECAM” appear on the display
in sequence.
About the color system
When wrong color system is selected, picture on TV
screen will lose the color.
TAPE A
EN14-20.CA-MXDVA5[UG]_f 01.3.23, 1:40 PM15