Filter
Top Products
42
english
Jabra GO 6470 USER MANUAL
The precise eect of each type of gesture depends on what you are currently doing (e.g., if you are already on a
call, which phone is the current target, etc.). The table below summarizes all of the control possibilities presented
by the multifunction button.
Function Tap
Double-
Tap
Press
(hold 1-3 sec)
Long Press
(hold 3-5 sec)
Answer incoming call
Connect to the current target phone
(e.g., go to dial tone; voice-activated dialing)
Enable voice-activated dialing (when target is
a cell phone that supports this)
End current call (and activate held or incoming
call, if any)
Call the last number dialed on current target
phone (supported softphones and mobile
phones only)
Reject incoming call (when already on a call)
Switch target phone (when no call is active)
Power-on headset
(when power is o)
Reject incoming call (when no call is active)
Hold current call and switch to held or
incoming call (supported softphones and
mobile phones only)
Power-o headset
(when power is on)
Activate Bluetooth® pairing mode (when power
is o)
Table 3: All multifunction button commands
The Touch Panel
The headset features a touch panel that is similar to the touch pad included with many laptop computers. Use it
to adjust the volume you hear in your headset and to mute/unmute the microphone.
- Slide your nger up the touch panel (away from your mouth) to increase the volume.
- Slide your nger down the touch panel to decrease the volume.
- Double-tap on the touch panel to mute or unmute the microphone.
See also Section 6.6: Controlling the Speaker Volume and Microphone.