Filter
Top Products
23
english
Jabra GO 6470 USER MANUAL
Connecting to the GN1000 Remote Handset Lifter
A remote handset lifter gives you remote call control with a Jabra GO headset up to 100 m away from your desk.
It lets you answer calls, end calls and transfer ring tones to the headset.
The GN1000 Remote Handset Lifter is an accessory available from Jabra. It is a motorized device that physically
lifts the handset when you use controls of your Jabra GO base or headset. You can use the handset lifter with
nearly any type of desk phone — including phones that also happen to have electronic-hookswitch support.
Figure 16:
Connecting to a GN1000 Remote Handset Lifter
To connect the Jabra GO base to a GN1000 RHL handset lifter, follow the instructions in the desk phone setup
wizard, as given below:
SELECT
Electronic hookswitch
adapter
Jabra GN1000
1. When you
reach the
touchscreen
shown left,
select Jabra
GN1000:
CONNECT
Unplug handset cable
2. In the rst
CONNECT
screen, shown
left, unplug
handset cable.
Figure 17: Select Jabra GN1000 Figure 18: Unplug handset cable
CONNECT TO BASE
3. In the (rst)
CONNECT TO
BASE screen,
shown left,
connect the
handset as
shown.
CONNECT TO BASE
4. In the (second)
CONNECT TO
BASE screen,
shown left, con-
nect the cable
with the blue
marking to the
base port, as
indicated in the
wizard.
Figure 19: Connect as shown here Figure 20: Connect as shown here