Filter
Top Products
24
english
Jabra GO 6470 USER MANUAL
CONNECT DESK PHONE
5. In the CON-
NECT DESK
PHONE
screen, shown
left, connect
to the handset
port.
CONNECT
6. In the (second)
CONNECT
screen, shown
left, connect
the control
cable attached
to the GN1000
to the base’s
AUX port.
Figure 21: Connect to the handset port Figure 22: Connect control cable to AUX port on the base
GN1000
Mount and configure
GN1000 on desk phone.
Follow the instructions in
GN1000 manual
7. In the (rst)
GN1000
screen, shown
left, mount
and congure
the GN1000
on the desk
phone.
GN1000
Did the GN1000 lift the
handset successfully?
Yes No
8. In the (second)
GN1000
screen, shown
left, you must
determine
whether the
desk phone
went o-hook.
If so, touch Yes.
Figure 23: Mount and congure on the desk phone Figure 24: Touch Yes if the handset was lifted
If the handset was not lifted, touch No. In this case, you can choose to Retry or Cancel. If you choose to retry, the
touchscreen takes you back to a point in this ow just after step1 (where Jabra GN1000 has been selected). If you
choose to cancel, the setup is aborted and the touchscreen takes you to the start of the cabling procedure for
conguration without EHS or GN1000. You can return to the GN1000 setup later.
GN1000
Check GN1000 manual to
adjust ring detector
9. In the (third)
GN1000
screen, shown
left, check the
GN1000 manual
to adjust the
ring detector.
GN1000
Congratulations, GN1000
installation complete
10. The (fourth)
GN1000 screen,
shown left,
lets you know
that the setup
is completed
successfully. Just
go to the next
screen.
Figure 25: Adjust the ring detector Figure 26: A successful setup
The wizard now leads you through the clear dial-tone and mic. level conguration. See the section “Conguring
the Jabra GO Base for your Desk Phone” for more.