Filter
Top Products
97
Zone 2
—Continued
Note:
•To control Zone 2, you must press the remote control-
ler’s [Zone 2] button first.
Adjusting the Volume of Zone 2
Adjusting the Balance of Zone 2
Muting Zone 2
Adjusting the Tone of Zone 2
Notes:
• Zone 2 can also be unmuted by adjusting the volume.
• The Zone 2 level, balance, and tone functions have no
effect on the ZONE 2 PRE OUT when the Zone 2 Out
setting is set to Fixed (page 95).
3
To turn off Zone 2, press the
[Zone 2] button, followed by the
[On/Standby] button.
On the remote controller, press
the [Zone 2] Remote Mode but-
ton, and then use the VOL
[ ]/[ ] buttons.
On the AV receiver, press the
[Zone 2] ] button, and then use
the Level Up and Down [ ]/[ ]
buttons.
1
On the AV receiver, press the
[Zone 2] button.
2
Press the AV receiver’s [Tone]
button repeatedly to select Bal-
ance.
AV receiver
Remote
controller
AV receiver
3
Use the Tone Plus [+] and Minus
[–] buttons to adjust the balance.
You can adjust the balance from 0 in the
center to +10 to the right or +10 to the
left in 2 steps.
On the remote controller, press
the [Zone 2] Remote Mode but-
ton, and then press the [Muting]
button.
To unmute a zone, on the remote
controller, press the [Zone 2]
Remote Mode button, and then
press the [Muting] button again.
1
On the AV receiver, press the
[Zone 2] button.
2
Press the AV receiver’s [Tone]
button repeatedly to select Bass
or Treble.
3
Use the Tone Plus [+] and Minus
[–] buttons to adjust the bass or
treble.
You can boost or cut the Bass or Treble
from –10 dB to +10 dB in 1 dB steps.
AV receiver