Filter
Top Products
100
Controlling Other Components
You can control your DVD player, CD player, and other
components with the AV receiver’s remote controller.
To control another component, you must first enter that
component’s remote control code to a Remote Mode but-
ton.
This section explains how to enter remote control codes
and how to control your other components.
The following Remote Mode buttons are prepro-
grammed with remote control codes for controlling the
components listed. You do not need to enter a remote
control code to control these components.
For details on controlling these components, see the
pages indicated.
Integra/Onkyo DVD player (page 103)
Integra/Onkyo CD player (page 106)
Onkyo cassette recorder with
(page 108)
You’ll need to enter a code for each component that you
want to control.
Note:
• The remote control codes provided are correct at the
time of printing but subject to change.
Preprogrammed Remote Control
Codes
Entering Remote Control Codes
Remote
Mode
Receiver
Display
Number
buttons
Remote
indicator
1
Look up the component’s remote
control code in the separate
Remote Control Codes list.
The codes are organized by category.
2
While holding down the Remote
Mode button to which you want
to enter a code, press and hold
down the [Display] button until
the Remote indicator lights up
(about 3 seconds).
Note:
• Remote control codes cannot be
entered for the [Receiver] and
[Zone 2] Remote Mode buttons.
• Only TV remote control codes can be
entered for the [TV] Remote Mode
button.
• Apart from the [Receiver], [TV], and
[Zone 2] Remote Mode buttons,
remote control codes from any cate-
gory can be entered for the Remote
Mode buttons. However, these but-
tons also work as input selector but-
tons (page 48), so choose a Remote
Mode button that corresponds with
the input to which you connect your
component. For example, if you con-
nect your CD player to the CD input,
choose the [CD] Remote Mode but-
ton when entering its remote control
code.
3
Within 30 seconds, use the num-
ber buttons to enter the 5-digit
remote control code.
The Remote indicator flashes twice.
If the remote control code is not entered
successfully, the Remote indicator will
flash once slowly.
(3 seconds)