Filter
Top Products
112
Troubleshooting
—Continued
The AV receiver can upconvert component video, S-Video, and composite video sources for display on a
TV connected to the HDMI OUT. However, if the picture quality of the source is poor, upconversion may
make the picture worse or disappear altogether.
In this case, try setting the HDMI Output Resolution setting (page 90) to 480p or 720p. If that doesn’t
improve the picture quality, try the following:
1. If the video source is connected to a component video input,
connect your TV to the COMPONENT VIDEO OUT.
If the video source is connected to an S-Video input,
connect your TV to an S-Video output.
If the video source is connected to a composite video input,
connect your TV to a composite video output.
2. On the main menu, select “1. Input Assign,”
and then select “1. HDMI Input.”
Select the relevant input selector, and assign it to “-----” (page 44).
3. On the main menu, select “1. Input Assign,”
and then select “2. Component Video Input” (page 45):
If the video source is connected to COMPONENT VIDEO IN 1,
select the relevant input selector, and assign it to “IN1.”
If the video source is connected to COMPONENT VIDEO IN 2,
select the relevant input selector, and assign it to “IN2.”
If the video source is connected to an S-Video input or composite video input,
select the relevant input selector, and assign it to “-----”.
The AV receiver contains a microcomputer for signal pro-
cessing and control functions. In very rare situations,
severe interference, noise from an external source, or
static electricity may cause it to lockup. In the unlikely
event that this happens, unplug the power cord from the
wall outlet, wait at least 5 seconds, and then plug it back
in again.
Integra/Onkyo is not responsible for damages (such as
CD rental fees) due to unsuccessful recordings caused
by this unit’s malfunction. Before you record important
data, make sure that the material will be recorded cor-
rectly.
Before disconnecting the power cord from the wall out-
let, set the AV receiver to Standby.
Important Note Regarding Video Playback