Filter
Top Products
13
Controls & Connectors—Continued
The page numbers in parentheses show where you can find the main explanation for each item.
A RS 232
This port is for servicing.
B IR IN/OUT (23)
The IR IN connector can be used to connect a com-
mercially available IR receiver, which can be used
to pickup signals from the remote controller when
the DPC-7.7 is located in another room, installed in
a rack, or is out of range of the remote controller
The IR OUT connector can be used to connect a
commercially available IR emitter, which can be
used to pass remote controller signals received by
the IR IN along to other AV components.
C REMOTE CONTROL
These (Remote Interactive) connectors can be
connected to the connectors on your other Inte-
gra/Onkyo AV components for interactive control.
D COMPONENT 2 VIDEO OUTPUT
These BNC connectors can be used to connect a TV
or projector with BNC component video inputs.
The DPC-7.7 has two component video outputs, the
COMPONENT 1 and COMPONENT 2, however,
they output the same video signal.
E ANALOG AUDIO OUTPUT
These RCA/phono connectors can be connected to
the analog audio inputs on your TV, hi-fi amp, AV
receiver. There are two sets of outputs. You could
connect one set to your AV receiver, the other to
your TV for those occasions when you want to
watch a DVD-Video but don’t want to use your AV
receiver.
The DPC-7.7 has two pairs of stereo analog audio
output connectors. They output the same audio sig-
nal respectively.
F COAXIAL AUDIO OUTPUT
This coaxial digital audio output can be connected
to a coaxial digital audio input on a hi-fi amp, AV
receiver, or surround sound decoder (Dolby Digital,
DTS).
G OPTICAL AUDIO OUTPUT
This optical digital audio output can be connected to
an optical digital audio input on a hi-fi amp, AV
receiver, or surround sound decoder (Dolby Digital,
DTS).
H HDMI OUT
This HDMI jack outputs digital video and audio and
can be connected to an HDMI input on a compatible
TV or other component.
I COMPONENT 1 VIDEO OUTPUT
These RCA/phono connectors can be used to con-
nect a TV or projector with RCA/phono component
video inputs.
The DPC-7.7 has two component video outputs, the
COMPONENT 1 and COMPONENT 2, however,
they output the same video signal.
J S VIDEO OUTPUT
These connectors can be used to connect TVs or
projectors with S-Video inputs.
The DPC-7.7 has two S-Video output connectors.
They output the same video signal.
K VIDEO OUTPUT
These RCA/phono connectors can be used to con-
nect TVs or projectors with composite video inputs.
The DPC-7.7 has two composite video output con-
nectors. They output the same video signal respec-
tively.
L AC INLET
The supplied power cord is connected here. The
other end of the power cord should be connected to
a suitable wall outlet.
See page 18–23 for connection information.
Rear Panel
1 3 42
5 6 8 9 J K7 L