Filter
Top Products
Chapter 2: WEB Configuration
Illustrations contained in this document are for representation only.
61
MAC Restrict Mode : Click Disabled to welcome all of the clients on the network; select Allow to
permit only the clients on the list to access the cable modem; or choose Deny to prevent the clients on
the list to access this device.
MAC Address : Your Gateway identifies wireless PCs by their WiFi MAC Address. This address
consists of a string of 6 pairs of numbers 0-9 and letters A-F, such as 00 90 4B F0 FF 50. It is usually
printed on the WiFi card of the device (e.g. the PCMCIA card in a laptop). It can also be determined
from a Windows DOS prompt as explained below.
Enter the MAC addresses of the connected clients into the fields, and then click Apply to add them to
the list for access control.
Apply : After proper configuration, click Apply to invoke the settings.
Connected Clients : The information of currently connected clients will be displayed here.
4.
4. 4.
4. 802.11b/g
802.11b/g 802.11b/g
802.11b/g Advanced
AdvancedAdvanced
Advanced
This page allows you to configure some advanced settings. The factory default values should provide
good results in most cases. We don’t recommend you change these settings unless you have technical
knowledge of 802.11b wireless technology.
For expert users, details of all settings on this web page are provided below.
Fig. 43
Beacon Interval: