Filter
Top Products
Chapter 2: WEB Configuration
Illustrations contained in this document are for representation only.
54
You can choose 64-bit or 128-bit according to your needs. If you choose Disabled, the Network Keys
will not be shown on this page. If selected, the data is encrypted using the key before being transmitted.
For example, if you set 128-bit in this field, then the receiving station must be set to use the128 Bit
Encryption, and have the same Key value too. Otherwise, it will not be able to decrypt the data.
( Note: You need to connect one end of the Ethernet cable to the Ethernet port on the back of your
computer, and the other end to the ETHERNET port on the Wireless Voice Gateway. )
If you select WEP (64-bit or 128-bit), you can adjust the following settings-
Shared Key Authentication : Decide whether to set the shared key Optional or Required by
selecting from the drop-down menu.
Network Key 1 to 4 : The system allows you to enter four sets of the WEP key. For 64-bit WEP
mode, the key length is 5 characters or 10 hexadecimal digits. As for 128-bit WEP mode, the key
length is 13 characters or 26 hexadecimal digits.
Current Network Key : Select one set of the network key (from 1 to 4) as the default one.
PassPhrase : You can enter ASCII codes into this field. The range is from 8 characters to 64
characters. For ASCII characters, you can key in 63 characters in this field. If you want to key
in 64 characters, only hexadecimal characters can be used.
Generate WEP Keys : Click this button to generate the PassPhrase.
Fig. 32
Apply: After proper configuration, click Apply to invoke the settings.
802.1x Authentication
802.1x Authentication802.1x Authentication
802.1x Authentication
If you enable the 802.1x authentication function, you will have to offer the following information-
RADIUS Server : RADIUS Server is a protocol for carrying authentication, authorization, and
configuration information between a Network Access Server which desires to authenticate its
links and a shared Authentication Server. Please key in the IP Address for the RADIUS Server.
RADIUS Port : Besides the IP address of the RADIUS Server, you have to enter the port number
for the server. Port 1812 is the reserved RADIUS-authentication port described in RFC 2138.