Filter
Top Products
Manual Fusion Intelpage IP
© CommtechWireless Page 45
4.3 Updating Firmware
To update the firmware of the INTELPage unit, run FirmUpd.exe. The window shown
below will then appear.
Click on the Browse button and select the “ethertx.hex” file. The COM port selection
screen will then appear as shown in the figure below.
From the drop down menu, select the COM port that the INTELPage unit is connect to
and click on Next. You will then be informed to turn OFF power to the unit first and then
click Start.
After clicking Start, you will then be presented with a window asking you to turn ON the
power to the unit in order to start the boot loader.
Once there is power to the unit, the firmware will begin to be sent. A blue progress bar
will indicate how long there is left to go. Once finished, you will be informed that the
Firmware load is complete.