Filter
Top Products
Fusion Intelpage IP Manual
Page 26 © CommtechWireless
4. A reservation has been created. The next time the transmitter is re-powered with DHCP
enabled, the DHCP server should assign the device an IP address automatically. In the
example, this would be 192.168.0.9.
3.2.2 Configuring through TCP/IP Example
NOTE: Internet Explorer is used in the following example. If it is not installed, it can be
added by changing your Windows settings. Other browser programs may be used.
1. Using an RJ45 cable, connect the Intelpage IP 5 unit to the network (LAN).
NOTE: You can also connect the Intelpage IP 5 directly to a PC’s network card if you use
a “crossover networking cable” if you do not have access to a HUB or LAN.
2. If you have set up DHCP and reserved an IP address for the Intelpage IP 5, skip to step 3.
If you are manually setting up the IP address, mask and gateway (DHCP disabled or not set
up) ensure that no other PC on the network has the same IP address as that of the Intelpage IP
5 unit (by default it is 192.168.0.100).
3. Make sure that the power is
currently plugged into the Intelpage IP 5 unit at this stage. Check
that the power LED is on and the busy LED has turned off after initializing.
4. Start Internet Explorer. It can generally be found from the Windows start menu by selecting
Start -> Programs -> Internet Explorer.
5. In the Address field of the Internet Explorer window, type in the IP address of the Intelpage IP
5 unit (by default it is 192.168.0.100) and press [Enter].