Filter
Top Products
Fusion Intelpage IP Manual
Page 40 © CommtechWireless
Survey
This section is used to test a site by sending messages periodically. One person is required for
a site survey. Once you have triggered the site survey, walk around the area intended to be
covered by the transmitter making particular note of the quality of messages received by the
test pager. The Troubleshooting Guide later on in this manual contains some useful tips on
improving coverage and performance.
• Capcode - Enter the cap code of the test pager that you wish to use in the site survey.
• Interval - Enter the time between test messages sent out in seconds here.
• Type - Enter the encoding type used on the pager. Select between Alpha, Numeric,
Tone Only or Disabled.
• Survey Enable - Check this option to enable the site survey with the above settings.
• Transmitter Test Enable - Check this option to force the transmitter to send out a
constant preamble signal. This is useful when testing the transmitter on a test set.
▲ WARNING: This test mode causes the transmitter to heat up rapidly. Do not
use this test for extended periods of time as it may damage the transmitter.