Filter
Top Products
Fusion Intelpage IP Manual
Page 10 © CommtechWireless
1.3 Rear Panel
1.3.1 Connectors
• Ethernet
The RJ45 Ethernet port may be used for connection to a PC or external system
for configuration or operational purposes.
• RS232
The RS232 port may be used for connection to a PC or external system for
configuration or operational purposes. Details of the required RS232 pins are as
follows:
The pinouts are described below.
Abbreviation Pin Number
GND 4
RX 5
TX 6
CTS 7
RTS 8
Antenna Port
The antenna port is an opening to allow connection of the antenna to the internal
transmitter. The connector is a standard BNC 50ohm.
1.3.2 DC Input
This connector is used to supply power to the unit. The CMM requires 12VDC @ 2amps
regulated. You will have been supplied with a suitable power supply with mains lead
which will plug straight into this socket.