Meridian Audio G68 Stereo Receiver User Manual


 
Troubleshooting
56
Remote not working
Check the following:
•The battery in the MSR+.
Remove the Comms connections from the G68 and check
whether it responds now. If so, replace the connections and
perform an Auto Configure procedure; see
To connect to other
Meridian G Series, 500 Series, or 800 Series equipment
, page 23.
See if the G68 has been set up as Not Controller in the
Configuration Menu; see
Configuring other settings
, page 32.
Note: This may be deliberate by your dealer.
When playing a Dolby Digital DVD, the G68 selects a two-
channel preset
DVDs include a two-channel Dolby Digital soundtrack, which will
use the default two-channel preset.
Select a six-channel soundtrack, if it is available.
Unit is overheating
Check that there is adequate ventilation around the unit.
Audio problems
Hum on analogue input
Check the source equipment. Disconnect each source in turn.
If the hum originates from a ground loop, an antenna or cable
supply may be the cause. In this case an antenna-lead isolator
should be fitted.
If the G68 seems to be the cause of hum consult your dealer.
There is radio interference
The G68 is a digital audio and computing device which has been
designed to very high standards of electromagnetic compatibility.
If this equipment does cause or suffer from interference to/from
radio or television reception then the following measures should
be tried:
Reorient the receiving aerial (or antenna) or route the antenna
cable of the receiver as far as possible from the G68 and its
cabling.
Ensure that the receiver uses well-screened antenna cable.
Relocate the receiver with respect to the G68.
Connect the receiver and this product to different AC outlets.
If the problem persists contact your dealer.
G Series DSP 56 31/10/03, 4:24:48 pm