Configuring the
digital surround
controller
28
Stage 2: Configuring speakers
The Speakers configuration stage allows you to set up the digital
surround controller for the particular arrangement of loudspeakers
in your system.
To configure the speakers
Either:
•Press Next after
resetting the product; see page 26.
Or:
•Press Wizard; see page 25.
•Press Skip to skip past the Reset settings menu.
The display shows the title screen for stage 2:
SkipBack Enter
2: Select speakers
Press More for help
•Press Enter to proceed or Skip to go to stage 3.
The display shows the first speaker configuration option:
öõú óòô Back Next
Number of Subwoofers:
one
•Press Next or Back to step between options.
A description of each option is shown on the top line of the
display, and its current value is shown below this to the right.
The options are summarised in the table on the next page.
To change an option
•Press A or V to step between the alternative values for the
option.
When you have stepped through all the speaker options the display
shows:
Back Next
Speaker choice finished.
Either:
•Press Next on the last option of the last speaker to proceed to
configuring sources, as described in the next section.
Or:
•Press On/Off to return to standby.
If you press On/Off before completing the configuration a warning
is displayed, giving you the option of continuing or abandoning the
configuration.
G Series DSP 28 31/10/03, 4:24:13 pm