Filter
Top Products
Installing the
digital surround
controller
23
To connect to other Meridian G Series, 500 Series, or 800 Series equipment
COMMS
COMMS LEAD COMMS LEAD
G Series, 500 Series, or 800 Series unit
COMMS
G68 Digital Surround Controller
In a system of Meridian products, one of the products acts as
the controller for the system, receiving infra-red commands from
the MSR+, and then, if appropriate, relaying them to the other
products via the Comms link.
The following procedure should be used to set up the Comms
correctly between several products:
•Connect one of the DIN COMMS sockets on the back panel of
the digital surround controller to one of the COMMS sockets
on another G Series, 500 Series, or 800 Series unit, using the
Comms leads provided with the products.
The sequence in which you connect the units is not important.
•Switch all the units to standby.
•Press Clear (MSR+).
Each unit will display:
Auto
One unit will then be designated as the controller, and display:
Con.
All the other units will be configured as non-controllers, and
display:
Not Con.
The system is now ready for use.
If the automatic setup does not work, first make sure you are
operating the MSR+ from a position where all the units can receive
the infra-red, and try again. Then:
•Check that none of the units have been configured to be IR
Controller; see
Configuring other settings
, page 32. Either all
products should be set to Auto, or one should be configured as
Controller and the others as Not Controller.
G Series DSP 23 31/10/03, 4:24:06 pm