Filter
Top Products
66
Warning Messages
The following shows the warning messages that can be displayed on the screen. When a warning message is displayed, take
the corrective action described here.
Message Cause Corrective action Page
• No device is connected to the
input terminal.
•The terminal is connected but no
signal is output from the
connected device.
*The selected input mode (input
terminal) name is shown in the
first line of the massage.
• Connect a device to the selected
terminal.
•Operate the connected device
and output a signal.
9, 11,
24 ~ 29,
33
•The frequency of the input video
signal is out of range.
•The selected input mode (input
terminal) name is shown in the
first line of the message.
• Input the video signals whose
frequency is within the projector’s
specifications.
22, 23,
70
•Though the frequency of the input
video signal is within the
acceptable range, other items
such as resolution are out of the
projector’s specifications.
•The selected input mode (input
terminal) name is shown in the
first line of the message.
• Input the video signals that
satisfies the projector’s
specifications.
22, 23,
70
•When the FREEZE button is
pressed, this message appears
for a few seconds.
•When a button not acceptable is
pressed during freezing, this
message appears for a few
seconds to notify that the image is
being frozen.
•To release freezing, press the
FREEZE button on the remote
control.
12, 37
•When the FREEZE button is
pressed for the video signals that
cannot be frozen (UXGA 60Hz,
SXGA 60Hz.), this message
appears for a few seconds to
notify that the image cannot be
frozen.
*To forcibly clear the message,
press the EXIT button.
• Freeze function does not work for
the inputted video signals.
To use this function, input the
video signals that can be frozen.
12, 37
PC 1
No Input
PC 1
Frequency of input signal is out of range.
PC 1
Signal is not supported.
FREEZE
FREEZE