Meridian Audio FDP-DILA2 Home Theater System User Manual


 
14
Controls and Features
Installing Batteries
Install batteries in the remote control. If the remote control has started to work erratically, replace the
batteries.
1 Open the back cover.
Open the back cover in the direction of the arrow.
2 Install the batteries.
Place the two supplied batteries (AA/R6-size) in the
remote control as illustrated below.
3 Close the back cover.
First fit the claws on the back cover in the case, then
close the back cover in the direction of the arrow.
Precautions for using batteries
If batteries are used incorrectly, they may crack or
leak liquid. This could cause a fire, burn, malfunction,
or staining or damaging of the surroundings.
Beware of the following:
•Do not mix new and old batteries.
•Do not mix different types of batteries as they differ in
characteristics.
•Place batteries so they match the polarities indicated:
(+) to (+) and (–) to (–).
Be sure to put the minus (–) end in first to avoid
short-circulating.
Use only designated batteries.
Remove the batteries if the remote is not to be used for a
prolonged period.
•When the batteries are exhausted, replace them
immediately. Otherwise, liquid could leak, or malfunction
could occur due to leaking liquid. If the leaked liquid
contacts the skin, wipe it off with a cloth, otherwise the skin
could become rough.
•Do not put batteries into a fire or try to recharge them.
Batteries run for six months to one year in normal use.
However, the batteries supplied are for confirming
operation and may not run that long. When the remote
control starts failing to work properly, replace the batteries
with new ones.